Vise Jaw Liners With a Little 'Give'
Scrap pieces of composite decking boards make ideal jaw liners for a woodworking vise. Compared with a wood liner, the rubbery surface has more give and grip. That makes composite liners good for holding cylindrical or oddly shaped work pieces. And when you release the clamp, the composite liner returns to its original flatness.
Space-Saving Cutting and Finishing Bench
Save space and make plywood cutting easier by building this hinged, flip-up, open-web bench. It’ll take some care and patience to cut the interlocking joints, but after that, assembly is a cinch. Make everything from 1x4s. The bench shown is about 3 x 5 ft.—a good size for nearly any plywood cut. Keep the screws at least 1/4 in. from the top edge. Get it out of the way by tipping it up against the wall and locking it into place with a wooden turnbuckle, turned behind a 1×2 catch block that’s mounted with the thin side against the front board.
The grid work provides solid, even support for sawing or finishing. But make sure to set your saw to cut only 1/8 in. into the table so you don’t hit any of the assembly screws or weaken the table. Thanks to Bob Dawson for this cutting-edge tip.
A vinyl tablecloth—any size—comes in handy for all kinds of woodworking jobs (available at discount stores). Put it under boards you're gluing together. Any glue drips will easily peel off the plastic surface after they dry. Or place the tablecloth as a thin cushion under workpieces you're sanding and finishing, and use it as a protective barrier between the workbench and project parts when you're tapping that next masterpiece together.