Here’s a great gift idea that will draw raves. The joints are accurately made in seconds with a plate jointer, but don’t tell your admirers. You’ll also need a power saw to crosscut the boards and a jigsaw to cut the half-circles in the risers. The lumber you’ll need:
- One 8-ft. 1×8 clear hardwood board (actual width is 7-1/4 in. and actual thickness is 3/4 in.). Oak is a good choice because it’s readily available at home centers.
- One 4-ft. 1×3 hardwood board (actual width is 2-1/2 in. and actual thickness is 3/4 in.).
Cut the 8-ft. board into:
- Two 22-in. riser boards
- Two 11-in. riser boards
- One 14-in. step board
- One 14-in. seat board
You’ll use 94 in. of the 96-in. board, so make practice cuts on a scrap board first to check the angle and length of cut. Don’t cut the 3-ft. 1×3 board until you’ve dry-assembled the step, seat and risers and measured for a perfect fit.
To create two risers, join the 11-in. boards to the 22-in. boards with No. 20 biscuits and glue. Let dry 30 minutes, then lay the step and seat across and mark for two No. 20 biscuits at each joint. Dry-assemble the step, seat and risers with biscuits, then cut and snugly fit the crosspieces. Mark the riser-to-crosspiece joint and cut slots for No. 0 biscuits. Glue and firmly clamp the step, seat and crosspieces to the risers. Check for square and let dry 30 minutes, then cut out the 4-1/2 in. diameter arc on the bottom of the risers to create the legs. Finish-sand and apply your favorite finish. This project is designed for use on hard-surface flooring only – not carpeting. We’ve got plans for lots of different simple stools, like this one that you make using your jigsaw.