- 4-in-1 screwdriver
- Drill bit set
- Drill/driver - cordless
- Toilet seat stabilizer kit
- Toilet seat tightening kit
The basics of toilet seat repair
Forum reader “tank_military” asked for advice on keeping a toilet seat tight for more than a few months at a time. Another forum member advised that he change out the plastic toilet seat bolts to steel. We think that’s just a temporary fix too.
Here’s a more permanent fix. Buy a We'll show you how to do it below.
Plus, save money by doing simple plumbing repairs yourself. These 10 plumbing fixes are completely DIY with basic tools and skills.
Project step-by-step (4)
Install rubber bushings
To begin remove the toilet seat nuts and insert the rubber bushings. Install the rubber bushing with the tapered side facing up toward the toilet seat. Then use the tightening tool from the kit to snug up the nut.
Close-up of bushing kit
Rubber bushings slide on the seat bolt and the supplied tool helps with tightening.
Locate and install seat stabilizers
Then install a set of toilet seat stabilizers, such as . Loop the rubber band around the toilet seat and center the stabilizers so they touch the inside rim of the bowl. Drill a starter hole and secure the stabilizers with screws from the kit.
Plastic stabilizers keep the seat centered on the toilet. They'll eliminate loosening caused by side-to-side movement.
A plumber isn’t obliged to tell you it’s an easy fix… check out these 12 things your plumber doesn’t want you to know.