Install door reinforcement hardware
Photo 1: Reinforce the door
Slide the reinforcement plate onto the door and insert the dead bolt and dead latch. Secure them with 1-1/2-in.-long stainless steel screws. Then secure the plate to the door with the matching screws from the kit.Photo: Courtesy of We do everything by our own hands
You can spend hundreds on a fancy “pick-proof” dead bolt for your entry door. But you’re kidding yourself if you think that’ll stop most burglars. The truth is, most don’t know how to pick a lock. They gain entry with one really well-placed kick or body slam that splits the doorjamb (and often the door as well), and they walk right in. You can stop burglars in their tracks by beefing up your door and jamb with reinforcing hardware. The components cost about $120 and take about an hour to install. Here’s how to do it.
Start by measuring the entry door thickness and the spacing between the entry knob and the dead bolt cylinder. Then buy either a single or a double wrap-around door reinforcement plate kit (less than $20 at any home center or hardware store) and four 1-1/2-in.-long stainless steel wood screws. Then get a doorjamb reinforcement kit (StrikeMaster II is one brand; around $80 from or through our affiliation with ).
Remove the entry knob and dead bolt cylinder. Then remove the dead bolt and latch and toss the short screws. Install the wrap-around door reinforcement plate and reinstall the latch and dead bolt plates using the longer stainless steel screws (Photo 1).
Install jamb reinforcement hardware
Photo 2: Mark the latch and bolt centers
Extend the dead bolt slightly and close the door. Mark the center of the bolt on the edge of the doorjamb with a pencil. Then mark the center of the latch on the jamb.Photo: Courtesy of We do everything by our own hands
Photo 3: Attach the jamb reinforcement plate
Extend the pencil marks to the door stop. Then line up the center of the latch alignment hole on the reinforcement plate with the centerline mark. Slide the plate into place. Predrill two holes and run the supplied screws almost all the way into the jamb with your drill. Stop before they’re seated or you’ll bow the door frame.Photo: Courtesy of We do everything by our own hands
Next, mark both the latch and the dead bolt “centers” on the strike side of the jamb (Photo 2). Remove the latch and strike plates and weather stripping from the jamb. But leave any weather stripping that’s attached to the door stop. Then align the reinforcement plate, predrill a few mounting holes and add screws (Photo 3). Check the reinforcement plate alignment before snugging the screws by hand. Do not overtighten.
If the prescored dead bolt knockout lines up with the marking along the jamb, remove it and finish installing the remaining screws. If it doesn’t line up, drill a new dead bolt hole with a 3/4-in. bimetal hole saw. Finally, replace two screws in each hinge with the longer screws provided in the kit.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Drill bit set
- Drill/driver - cordless
- Tape measure
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Door and jamb reinforcing plates