Step 1: Buy the kit and prep the surface
Photo 1: Cut away loose vinyl
Tape around the damage. Cut out any loose fragments with a utility knife. Clean dust or dirt from inside the damaged area with a damp rag, and smooth rough edges with the enclosed sandpaper.
The easy maintenance of vinyl and linoleum flooring makes it ideal for bathrooms, kitchens and other busy areas. However, heavy, hot or sharp objects can damage this tough material, and nothing looks worse in the middle of the floor than a conspicuous blemish. The Vinyl Floor Repair Kit allows you to repair those unsightly burns, cuts and gouges in your vinyl or linoleum flooring. It'll disguise imperfections up to the size of a quarter. The kit is available at hardware stores or online. Prepare the surface for patching as shown in Photo 1. Keep the tape 1/2 in. back so the repair adhesives don't glue it to the floor.
Step 2: Mix and apply paint
Photo 2: Mix paint to match the vinyl
Mix the paint to match the floor color, and paint the inside surface and edges of the damaged area. Clean off any paint that gets on the surrounding vinyl surface. Let the paint dry for 15 minutes, or speed up the drying time with a hair dryer on low heat.
Mi the special paint to match your flooring color is the trickiest part of the fix (Photo 2). The included color-matching guide will help you determine basic colors, but a closer match will require a little trial and error. An exact color match may not be possible, but if it's close, it'll be virtually indistinguishable at normal viewing distances.
Check the color mix by dabbing test samples on a piece of clear packing tape laid on the floor. Add small amounts of color to the mix until you find a close match. Dark colors will lighten slightly and light colors will darken slightly after the hole is filled.
Step 3: Add filler and floor bond
Photo 3: Fill and bond
Pour filler powder into the hole and level it off with the enclosed smoothing paddle. Hold the floor bond right over the filler powder. Slowly drip the bond onto the filler powder until the powder is saturated (it'll only take three or four drops to cover a dime-size area). Let the compound harden for 15 minutes.
The filler and floor bond level the hole flush with the rest of the floor (Photo 3).
Step 4: Sand smooth and finish
Photo 4: Apply acrylic finish
Brush the clear acrylic finish over the repair, and allow two hours' drying time before walking on the area.
If the surface appears rough after the bond dries, lightly sand it smooth with the enclosed sandpaper (be careful not to scratch the surrounding floor surface). Protect the repair with clear acrylic finish (Photo 4).
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Utility knife
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Vinyl repair kit