Bring the outlet flush with the wall
Wrap electrical tape around the outlet to guard against accidental short circuits. Fit the extension ring around the outlet, then screw it in.Photo: Courtesy of We do everything by our own hands
Adding wood wainscoting or paneling? Remember that electrical boxes need to be flush with the wall. You can move the boxes out, but you’d have to cut the wall open. It’s easier to use a plastic or steel extension ring. They’re available up to 1-1/4 in. deep.
To install an extension ring, first turn off the power to the receptacle at the main panel, then remove the cover plate and unscrew the receptacle from the box. Pull the receptacle away from the box (don’t disconnect the wires). If you’re using a steel ring, press a grounding clip onto it and connect a 6-in. grounding wire. Connect the other end to the ground pigtail. Fasten the receptacle back to the box using the longer screws that come with the extension ring.
Turn off power to the outlet at the breaker box before opening the outlet, then test the wires with a voltage tester.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Electrical tape
- Needle-nose pliers
- Non- voltage tester
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Extension ring