Remove the old switch
Photo 1: Replace your fan switch
Follow the instructions included with the DewStop switch. Make sure the Power is off before you touch any wires in the box.
Photo 2: Installed switch
The new switch fits in the same spot as the old switch. You may have to buy a new cover plate, though.
If you just turn your bath fan on when you start a shower and off when you leave the room, it doesn’t run long enough to remove excess humidity. If you leave the fan running too long, you’ll waste energy.
A new fan control switch called DewStop solves both problems. It calculates when condensation will occur and turns the fan on and off automatically to keep the humidity at an acceptable level. This computerized switch is a vast improvement over the humidistats that have been around for years. You simply replace the switch or timer that controls the fan with the DewStop switch. It’s available online at www.dewstop.com or from online retailers. If you’re replacing a double switch that controls the fan and the light, order the version that includes a light switch.
Turn off the power at the circuit breaker box before removing the old switch.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Electrical tape
- Non- voltage tester
- Wire stripper/cutter
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Fan Control
- Wire nuts