Adjust the storm door
Photo 1: Move the connecting pin to a different hole
Lock the door open and remove the pin. Connect the closer at the inner hole to make the door close harder. For a softer close, use the outer hole.
Photo 2: Tweak the adjustment screw
Turn the adjustment screw to make the door close harder or softer. Make a quarter turn, test the door and continue making quarter turns until the door closes just right.
If your storm door slams shut or won’t close hard enough to latch, try a few simple adjustments to make it close just right.
First, change the mounting position of the closer’s connecting pin (Photo 1). To remove the pin, you have to first lock the door open with the hold-open washer to release the tension on the pin. But there’s a good chance that your hold-open washer won’t work. In that case, open the door and snap a locking pliers (such as a Vise-Grip pliers) onto the closer shaft to hold the door open.
To repair the washer, slip it off the shaft, put it in a vise and make a sharper bend in it using a hammer. Or you can take the entire closer to a home center or hardware store and find a similar replacement. Some closers mount a little differently from the one we show. For example, you may find that the door bracket, rather than the closer, has two pinholes.
If moving the pin makes matters worse, return it to its original position and try the adjustment screw (Photo 2). Turn it clockwise for a softer close, counterclockwise for harder. If your door has two closers, treat them exactly alike. Adjust both screws equally and make sure their pins are in the same position.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Locking pliers