Build a permanent footing
A footing destined to fail
If the footing does not extend below the frost line, the footing will heave as the ground freezes and thaws.
Post set in concrete
Even if you're setting the deck posts in the ground, instead of on top of footings, the concrete still needs to extend below the frost line.
If your deck posts move up in the spring then settle back down as the weather warms, then you have a bad case of “frost heave-osis.” In the winter, the ground freezes from the top of the soil downward. The depth of frost penetration depends on the soil type, the severity of the winter, the amount of water in the soil and the depth of an insulating blanket of snow.
The frost depth varies by region. In frigid Minnesota, the frost depth is 42 in., whereas a warmer state like Missouri may have a frost depth of only 1 ft.
When you your local building department to get your building permit, ask what the frost depth requirement is and the required size and shape of the footings. Then dig the footing holes so that the bottoms of the footings are at or below the frost depth.
The mechanics of frost heave are complex, but here's a quick primer. Water in the surrounding soil collects and freezes into thin layers of frost called “ice lenses.”
When water freezes, it expands about 9 percent—think of how ice cubes are domed above the original water level in the ice cube tray. Ice exerts a pressure of about 50,000 lbs. per square inch—enough force to lift even a large building. A puny little deck on inadequate footings doesn't stand a chance.
The reason buildings and decks don't always return to their original height is that surrounding dirt sometimes fills in under the footing while it's lifted.
Heavy clay soils don't drain well, so they tend to have more frost heave problems than sandy, well-drained ones. But even if footings are deep enough, ice lenses can latch onto the rough surfaces of wood and concrete and lift footings and posts from the side. That's why concrete piers poured in waxed cardboard tubes and smooth wooden posts work well for below-grade support.
Here's how to get a solid, frost-proof footing:
- When you pour concrete footings, hold the cardboard concrete form tube about 12 in. up from the bottom of the footing. Do this by nailing the sides of the tube to the center of a tic-tac-toe grid of 2x4s at the top of the hole. Then dump concrete through the tube into the bottom of the hole. After the wide part at the bottom of the hole has filled, the tube will fill too.
- Flare the sides on concrete footings so the footings will resist heave in harsh winters when frost penetrates especially deep. Greater width at the bottom will also distribute weight over a larger area.
- Mound soil around the posts after the backfill settles to direct runoff water away from the post.
Ordering Premixed Concrete
If you're pouring more than a few footings, order premixed concrete from a ready-mix company. You'd be shocked at how many bags of concrete mix you'd have to mix by hand to fill a form tube.
Figure concrete volume by multiplying the height of the post and column in feet by the radius of the tube in feet squared times 3.14. Divide the total by 27 to get the cubic yardage you need to order. Add extra for the wide footing bases.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Posthole digger
- Tape measure
- Utility knife
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Form tube