Assemble an under bed storage box rollout
Some of the most useful and underutilized storage space in the bedroom is right under the bed, but you can take advantage of it with this durable rollout chest, made from a single sheet of plywood for $60. Plastic versions of under bed storage box are also available for as little as $20, but wood looks better, lasts longer and lets you custom-size your rollout.
Measure the distance between the floor and the bottom of the bed. Subtract 1/2 in. for clearance under the bed and 1/2 in. (on bare wood) to 1 in. (on thick carpet) for casters. Subtract another 1/2 in. for the hinged top to arrive at the maximum height for the storage box sides.
Mark all the pieces on a sheet of plywood and cut them with a table saw or a circular saw. Fasten 3/4- in. square nailers to the edges of the base with glue and finish nails or screws (1/2-in. plywood is too thin to nail into on edge). Attach the sides to the base, adding square nailers at the corners. Fasten the caster supports to the sides, then nail the outer side pieces to the caster supports.
Attach the front and back. Add the filler strips on top of the caster supports and the last nailer along the top edge of the back. Finally, nail on the fixed top, set the hinged top against it and screw on the hinges. Attach the hinges using 1/2-in. screws so they don’t stick through the top.
Figure A: Under Bed Storage Box Construction
Figure A, a Cutting List and a Materials List are available in format in Additional Information below.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Circular saw
- Drill bit set
- Drill/driver - cordless
- Tape measure
- Wood glue