Change the oil and air filter
Photo 1: Change the oil and filter
Loosen the air filter cover screw and drop the cover down. Pull out the old air filter and press in the new one (make sure the paper pleats are facing out). Replace the cover and firmly tighten the cover screw.Photo: Courtesy of We do everything by our own hands
It's just plain smart to tune up your lawn mower every spring. According to manufacturer Briggs & Stratton, a tune-up can increase fuel economy by a third, extend the life of the engine, reduce repair costs and decrease emissions by up to 50 percent.
The three main components involved in a mower tune-up are the air filter, spark plug and oil, all of which must be changed. The needed parts and supplies can be found at home centers and hardware stores.
Start by changing the oil. Run the engine for a few minutes to warm up the oil so it'll drain better. Stop the engine, remove the drain plug and empty the old oil (tilt the mower back to get it all out, if necessary). Replace the drain plug and fill the mower with oil until it's visible through the oil fill hole, or check the level on the dipstick, if so equipped.
A clean air filter helps maintain the proper fuel/air ratio, allowing the mower to burn less gas. Swap out the old air filter (Photo 1).
Replace the spark plug
Photo 2: Install a new spark plug
Pull off the spark plug wire and remove the old plug with a spark plug wrench or deep socket (13/16 in. or 3/4 in., typically). Hand-turn the new plug until the threads catch. Ratchet the plug down until it stops, then turn it another quarter turn (cranking down too hard can break the plug or render it nearly impossible to remove).Photo: Courtesy of We do everything by our own hands
Photo 2A: Close-up of spark plugs
The new plug should come with a proper size gap.Photo: Courtesy of We do everything by our own hands
Next, remove and replace the spark plug (Photo 2). If the plug's rusted tight, spray it with a penetrating lubricant like Liquid Wrench or JB80. Let it soak in for 10 minutes before trying to loosen the plug again.
The spark plug will be factory gapped, but make sure there is a gap between the electrode and overhanging arm. If you drop the plug and the overhanging arm bends tight to the electrode, the mower won't start.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Socket/ratchet set
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Air cleaner
- Engine oil
- Spark plug