Checking flow and clearing clogs
Photo 1: Check pump operation
Follow the washer tubing from the reservoir to the tee. Disconnect the tubing and have a friend press the washer button. A strong stream of washer fluid indicates a good pump but a clogged nozzle.Photo: Courtesy of We do everything by our own hands
Photo 2: Blow out the nozzle
Press a rubber-tipped compressed air gun against the nozzle opening and blow air backward through the nozzle (tubing still disconnected at the cowl). Then reconnect the tubing and try the washers again.Photo: Courtesy of We do everything by our own hands
If you press the button for windshield juice and nothing comes out, you probably have a clogged nozzle. Start your diagnosis by making sure there’s fluid in the reservoir. If so, check for fluid flow at the tee near the cowl (Photo 1). If that checks out, leave the tubing off the tee and clear out the nozzle with a compressed air gun (Photo 2). However, if you couldn’t get fluid flow at the tee, you probably need a new pump (see our article on “Windshield washer repair” ).
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Air compressor
- Air hose