Replace those car interior light bulbs you never think about
The auto light bulbs that burn out most often are the taillight, stop, turn signal, backup and headlight bulbs. But there are many other bulbs in a vehicle that could use your attention, too. These are the five most commonly neglected bulbs that can affect your driving experience. Check yours to see if they work, and pick up replacements at any auto parts store.
Map light bulbs
Pry off the lens and pull the bulb out of the spring terminals. Snap in a new bulb.
License plate bulb
Since a burned-out license plate light bulb can get you a ticket, replace it if needed. Unscrew the lens or release the locking tab. Twist the bulb socket a quarter turn and pull it out. Snap in a new bulb and reinstall.
5 automotive light bulb changing tips
We’re not going to ask how many DIYers it takes to change a light bulb. But did you know there are a few tricks to changing the light bulbs in your vehicle? Read the following tips and file them away in your long-term memory.
- Check the light bulb for signs of tungsten filament deposits. The darker the buildup, the closer it is to burnout.
- If you’re replacing a light bulb in an exterior socket, apply a very light coating of dielectric grease to the bulb’s s. That’ll prevent corrosion.
- A long-life light bulb is worth the price. It’ll last at least twice as long as the original, so you’ll most likely never have to replace it again.
- A “blue” bulb (Sylvania SilverStar is one brand) gives off whiter light, making it easier to see in the dark. Use them for dome, map, fog, and backup lights.
- Skin oils can cause light bulbs to swell and fail. It’s especially important to prevent swelling on headlight and fog light bulbs. But skin oils can also cause miniature bulbs to swell and fail. Always wear gloves when you handle automotive light bulbs.
High-mount stop light bulb
A burned-out high-mount stop light bulb can also earn you a ticket. Pry off the interior trim cover. Then rotate the socket a quarter turn and swap out the bulb(s).
Dome light bulbs
Pry off the dome light lens and spread the spring terminals. Drop one side of the “torpedo” shaped bulb out of the socket and lift the bulb out. Reverse to install.
Fog light bulbs
Most drivers don’t realize their fog lights are burned out until they’re needed most. If one is burned out, replace them both. Reach behind the fog light assembly to access the light bulb. If you can’t gain access, remove the entire assembly and then replace the bulb.
Required Tools for this Project
Flat-blade screwdriver or small prybar
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Various automotive light bulbs as required