Replace a dryer vent cover
Photo 1: Disconnect the old cap
Cut the old caulk with a utility knife and pull out the vent from the outside.Photo: Courtesy of We do everything by our own hands
Photo 2: Install the new cap
Insert the duct from the dryer into the new vent duct and wrap the joint with metal tape.Photo: Courtesy of We do everything by our own hands
A dryer vent cover is deliberately lightweight so they’ll open easily, but this flimsiness also means they’ll break easily. The caps, especially the type with multiple small flaps, also clog easily with lint. (Avoid this type unless you’re conscientious about cleaning it.)
To replace an old dryer vent cover, first pull apart the duct at the last joint inside the house. If they don’t pull apart easily, look for small screws holding the sections of pipe together. Next, remove the screws or nails used to attach the cap to the siding and cut through the caulk around the edges (Photo 1). Pull out the dryer vent cover, scrape away old caulk and dirt, and then wipe the siding clean so new caulk will stick.
Cut the new vent pipe to the same length as the old one, then slide it through the wall. Screw the cap to the siding and caulk around the edges with paintable caulk.
Finally, join the old duct inside the house to the new vent (Photo 2). Vent caps are available at home centers.
Video: Why You Should Upgrade Your Dryer Vent
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- 4-in-1 screwdriver
- Caulk gun
- Tin snips
- Utility knife
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Acrylic caulk
- Metal tape
- New vent cap